Hp officejet pro 8500 a910 not printing blue

#Hp officejet pro 8500 a910 not printing blue pdf

A single sided A4 image takes 30 seconds from pressing start while the same image in monochrome takes only 10seconds quite a difference.

#Hp officejet pro 8500 a910 not printing blue pdf

Printing in colour using a PDF of the London tube map (two pages) the first is the map and the second an index of all the station names with various colour symbols beside them, this printed in thirty seconds.Д¬opying can of course be done direct from the touchscreen on the unit and you have a full range of choices as to single of double sided, to increase or decrease the size etc. A full A4 image took the same time as four near 15x10cm images on a single sheet at 78seconds and the printing was so quiet that you had to listen to hear the printer actually working. Photo Printing was rather good on photo paper good depth, good colour and the produced image only the tiniest bit tacky on the back edge.

All the controls are on the 9.5x5.5cm touchscreen that can lift forward by up to 45degrees so reading it should be easy from any angle. While printing in draft mode still produces a nice sharp black image it is noisy and most might like a slightly slower speed (normal) as you could then carry on a conversation and paper is less spat out and more pushed out.Дuplex printing was not that slower and unlike a lot of other such units the back seems to line up correctly with the front. For some reason the printed always seemed to stumble while printing the last page (at least a couple of seconds) and the time from pressing print to the first page being produced was always between 15 and 25 seconds. These figures are accurate assuming you start вЂ“ as manufacturerвЂ™s tests do вЂ“ after page 1 and end just before the last page is printed.

Printing in draft mode (the fastest and noisiest) the 200 word document came in at 24PPM and the more normal 1500 word document spread over four pages printed only just a tad slower at 22PPM.